Comtech EF Data LPOD PS 1.5 - Config | Redundancy

Low Power Outdoor (LPOD) Amplifier/Block Up Converter (BUC)
Revision 15
Ethernet Interface Operation 4–25 MN-LPOD
4.5.3.4 Config | Redundancy
Appendix A. 1:1 REDUNDANCY
Figure 4-14. ‘Config | Redundancy’ Page
Redundancy
Click [Refresh] to see the latest page data.
Name
Description
Enable Redundancy Switch
Mode
Use the drop-down list to select the Switch Mode as follows:
• Off disables redundancy
• 1:1 Red TX enables 1:1 redundancy with transmit switch control.
• 1:1 Red TX+RX enables 1:1 redundancy with transmit and receive
switch control.
• Manual enables manual redundancy mode.
Click [Change] to save.
Online Status (read-only)
The active status for the unit displays Online or Offline.
Force Online
Click [Force Online] to force a unit to go active (online).