Comtech EF Data LPOD PS 1.5 - Config; Config | Amplifier

Low Power Outdoor (LPOD) Amplifier/Block Up Converter (BUC)
Revision 15
Ethernet Interface Operation 4–20 MN-LPOD
4.5.3 Config Pages
Use the Configuration pages to configure all operating parameters for the LPOD. Click
Amplifier, LNB, Utility, or Redundancy to continue.
4.5.3.1 Config | Amplifier
Figure 4-11. ‘Config | Amplifier’ Page
Amplifier
Click [Refresh] to see the latest page data.
Serial
Name
Description
Remote Address
Enter a valid physical remote address from 0001 to 9999.
Baud Rate
Use the drop-down list to select the operating baud rate as 2400, 4800, 9600,
19200, or 38400 baud.
Click [Change Serial Configuration] to save.