Comtech EF Data LPOD PS 1.5 - Page 153

Low Power Outdoor (LPOD) Amplifier/Block Up Converter (BUC)
Revision 15
Serial Interface Operation 5–33 MN-LPOD
Parameter
Type
(* indicates
End-of-Life)
Controller-to-Target
Instruction Code and
Qualifier
Arguments
for Command
or Query
Description of Arguments
(Note that all arguments are ASCII numeric codes from 48 to 57)
Target-to-Controller
(see Description of
Arguments)
Command Query
Response to
Command
Response
to Query
RF Power FET
Current Status
(Cont)
Q16=xx.x{CR}{LF}
NOTE: If the reported value is ≥1A, the format is xx.x; if the value is <1A, the
format is .xxx
Retrieve
Maintenance
Status
N/A
RMS?
213 bytes,
alphanumeric
Query only.
Returns maintenance status as per the following example:
<0001/RMS?{CR}
>0001/RMS={CR}
P24V1=024.1{CR} +24V power supply
P24V2=024.1{CR} +24V switch power supply
LNBVT=018.2{CR} +13/18V LNB power supply (SEE NOTE)
P13VT=013.4{CR} +13.5V power supply
P10V1=010.1{CR} +10V1 power supply
A10V1=010.1{CR} 10V1 on RF Module
A10V2=010.1{CR} 10V2 on RF Module (SEE NOTE)
P7V8T=007.8{CR} +7.8V power supply
P5V8T=005.8{CR} +5.8V power supply
P2V5T=002.5{CR} +2.5V power supply
P1V2T=001.2{CR} +1.2V power supply
N5V8T=-05.7{CR} -5.8V power supply
FANR1=100.0{CR} Fan 1 speed in percent
FANR2=100.0{CR} Fan 2 speed in percent (SEE NOTE)
BUCVT=008.3{CR} BUC tuning voltage (SEE NOTE)
FWPWR=+53.2{CR} Forward power in dBm
REFVT=001.8{CR} Reference osc. tuning voltage (SEE NOTE)
LNBCS=380.2{CR} LNB current supply in mA (SEE NOTE)
ATEMP=+40.0{CR} Heatsink temperature in Celsius
OTEMP=+25.0{CR}{LF} Outdoor temperature in Celsius (SEE NOTE)
NOTE: LNBVT, FANR2, A10V2, BUCVT, REFVT, LNBCS, and OTEMP appear if
the appropriate options are installed; otherwise, the values will report XXXX.
RMS=
RMS=x….x