Comtech EF Data LPOD - Key Operational Parameters and Faults

152 pages

Save Page as PDF

To Next Page

To Previous Page

LPOD C-/Ku-Band Outdoor Amplifier/ Block Up Converter (BUC) Revision 3

Appendix A MN-LPOD

A–16

This page is intentionally blank.

Main Page

Default Chapter27
- Table of Contents27
Table of Contents28
Tables30
Figures31
Preface33
About this Manual33
- Reporting Comments or Suggestions Concerning this Manual33
Conventions and References34
- Cautions and Warnings34
- Recommended Standard Designations34
- Trademarks34
- Metric Conversion34
Electrical Safety Notice34
Installation Guidelines Regarding Power Line Quality35
Warranty Policy36
- Limitations of Warranty36
- Exclusive Remedies37
Customer Support38
- Online Customer Support38
Chapter 1. INTRODUCTION39
Overview39
- Figure 1-1. Comtech EF Data LPOD C-/Ku-Band Outdoor Amplifier / BUC39
Functional Description40
Features40
- The Solid-State Advantage40
- Enhanced Standard Features40
- Built-In Redundancy Controller40
- Smart BUC" Functionality41
- Data Logging Capability41
- Optional Internal 10 Mhz Reference41
- Optional LNB Support41
Theory of Operation42
- SSPA Block Diagrams42
- Figure 1-2. LPOD PS-1 Block Diagram42
- SSPA Module43
- Figure 1-3. LPOD PS-2 Block Diagram43
- Cooling System44
- Monitor and Control (M&C)44
- LNB Operation44
- Power Supply44
- Block up Converter (BUC) Input45
Summary of Specifications46
- Characteristics46
- Optional Internal Reference47
- Optional LNB Bias / Reference47
- Environmental48
- Physical48
Dimensional Envelopes49
- Figure 1-4. LPOD Ku-Band PS-1 Dimensional Envelope (Waveguide Output)49
- Figure 1-5. LPOD C-Band PS-1 Dimensional Envelope (Coax Output)50
- Figure 1-6. LPOD PS-2 Dimensional Envelope51
- Figure 2-1. LPOD Connectors53
Chapter 2. System Connections, Installation and Operation54
Interface Connectors54
- 2.2.1 Connector J1 - RF in54
- 2.2.2 Connector J2 - RF out54
- Table 2-1. J2 RF Output54
- 2.2.3 Connector J3 - AC Power Mains55
- 2.2.4 Connector J3 - DC Power Mains56
- Connector J6 - COM1 (Remote Communications and Discrete Control Port)58
- Table 2-7. Connector J6 Pinout58
- Connector J9 - Output Sample (PS-2 Only)59
- 2.2.7 Connectors J10 and J11 - Optional Modem Rx and LNB Interfaces59
- 2.2.8 Ground Connector59
- Figure 2-2. LPOD Ground Connectors59
Standalone Installation of the LPOD60
Turning on the LPOD60
- Figure 2-3. Universal Pole Mounting Kit, PL/12319-161
- Figure 2-4. LPOD PS-1 Single Unit Mounting Kit, KT-000009562
- Figure 2-5. LPOD PS-2 Single Unit Mounting Kit, KT-000012563
Chapter 3. FLASH UPGRADING65
Introduction65
- Figure 3-1. Flash Upgrade Via Internet65
Ethernet FTP Upload Procedure66
- Home | Home .............................................................................................................. 4–967
Ethernet Management Interface Protocols69
SNMP Interface69
- 4.3.1 Management Information Base (MIB) Files70
- 4.3.2 SNMP Community Strings70
- Admin | Access ......................................................................................................... 4–1270
- 4.3.3 SNMP Traps71
- Config | Amplifier ..................................................................................................... 4–1571
Chapter 4. LPOD ETHERNET MANAGEMENT69
Overview69
Telnet Interface73
Web Server (HTTP) Interface74
- Web Server74
- 4.5.2 Enabling the Web Server Interface74
- 4.5.3 Web Server Interface Access75
- 4.5.4 Web Server Interface "Splash" Page76
- Status | Events ........................................................................................................... 4–2176
- Web Server77
Appendix A. 1:1 REDUNDANCY95
Introduction to Redundancy Operation95
1:2 Redundancy Mode95
1:1 Redundancy Mode95
Applicable Redundancy Commands97
Redundancy System Assembly Kits97
- Table A-1. KT-0000116 LPOD Rx Splitter / Cable Kit BOM98
- Table A-2. KT-0000098 LPOD C-Band Rx Switch Kit BOM98
- Table A-3. PL/7596-1 LPOD Ku-Band Rx Switch Kit BOM98
- Figure A-1. KT-0000098 LPOD C-Band Rx Switch Kit (Assembled View99
- Figure A-2. KT-0000098 LPOD C-Band Rx Switch Kit (Exploded View100
- Figure A-3. PL/7596-1 LPOD Ku-Band Rx Switch Kit (Assembled View101
- Figure A-4. PL/7596-1 LPOD Ku-Band Rx Switch Kit (Exploded View102
- Figure A-5. KT-0000104 LPOD PS-1 C-Band (Waveguide) 1:1 Redundancy Kit (Assembled View103
- Table A-4. KT-0000104 LPOD PS-1 1:1 Redundancy Kit BOM104
- Figure A-6. KT-0000104 LPOD PS-1 C-Band (Waveguide) 1:1 Redundancy Kit (Exploded View105
- Figure A-7. KT-0000090 LPOD PS-1 C-Band (Coax) 1:1 Redundancy Kit (Assembled View107
- Table A-5. KT-0000090 LPOD PS-1 C-Band (Coax) 1:1 Redundancy Kit BOM108
- Figure A-8. KT-0000090 LPOD PS-1 C-Band (Coax) 1:1 Redundancy Kit (Exploded View109
- Figure A-9. KT-0000089 LPOD PS-1 Ku-Band 1:1 Redundancy Kit (Assembled View111
- Table A-6. KT-0000089 LPOD PS-1 Ku-Band 1:1 Redundancy Kit BOM112
- Figure A-10. KT-0000089 LPOD PS-1 Ku-Band 1:1 Redundancy Kit (Exploded View113
- Figure A-11. KT-0000091 LPOD PS-2 C-Band 1:1 Redundancy Kit (Assembled View115
- Table A-7. KT-0000091 LPOD PS-2 C-Band 1:1 Redundancy Kit BOM116
- Figure A-12. KT-0000091 LPOD PS-2 C-Band 1:1 Redundancy Kit (Exploded View117
Appendix B. REMOTE CONTROL119
Introduction119
- B.1.5 Power Detector120
- B.1.6 some Common Commands120
Remote Control Protocol and Structure121
- B.2.4 Packet Structure122
Remote Commands and Queries126

Comtech EF Data LPOD - Key Operational Parameters and Faults

Table of Contents

Other manuals for Comtech EF Data LPOD

Related product manuals