LPOD C-/Ku-Band Outdoor Amplifier/Block Up Converter Revision 3
System Connections, Installation, and Operation MN-LPOD
2–8
2.3 Standalone Installation of the LPOD
Several kits are available from Comtech EF Data to mount and install standalone or redundant
LPODs, depending on the type of unit ordered and its operational frequency.
Refer to Appendix A. 1:1 REDUNDANCY for the available assembly kit options for 1:1 LPOD
redundancy configurations.
Figures on the pages that follow illustrate available standalone mounting kits:
FIGURE CEFD PART NO. DESCRIPTION
2-3 PL/12319-1 Universal Pole Mounting Kit
2-4 KT-0000095 LPOD PS-1 Single Unit Mounting Kit
2-5 KT-0000125 LPOD PS-2 Single Unit Mounting Kit
2.4 Turning on the LPOD
WARNING
Never turn the unit ON without proper waveguide termination on the J2 “RF
OUTPUT” port. Individuals can be exposed to dangerously high electromagnetic
levels.
The LPOD does not contain a ‘Power On/Off’ switch. The SSPA is powered ON by connecting the
J3 AC Power connector to the appropriate prime power source. The Mute or Transmit status of the
SSPA will automatically come up in the last stored state (factory default = Transmit on, not muted).
To Next Page
Loading...
