Comtech EF Data LPOD - Config | Utility; Figure 4-8. Config | Utility Page

LPOD C-/Ku-Band Outdoor Amplifier/Block Up Converter Revision 3
Ethernet Management MN-LPOD
4–18
Calibrate LNB Current
IMPORTANT
The LNB should be calibrated only when it is running at nominal operating
conditions.
The value of the LNB Current Supply (in mA) is provided here as a reference point. The LNB
current alarm upper and lower thresholds are determined by this calibrated LNB reference point and
the LNB current window setting.
To perform an LNB calibration and display the updated read-only value, click [Calibrate].
4.5.5.3.3 Config | Utility
Figure 4-8. Config | Utility page
The ‘Config | Utility’ page (Figure 4-8)
is used to configure LPOD operating parameters.
Date and Time
• The user may enter a date using international format in the form DD/MM/YY (where
DD = day [01 to 31], MM = month [01 to 12], and YY = year [00 to 99]).
• The user may enter a time using HH:MM:SS format (where HH = hour [00 to 23],
MM = minutes [00 to 59], and SS = seconds [00 to 59]).