LPOD C-/Ku-Band Outdoor Amplifier/Block Up Converter Revision 3
Ethernet Management MN-LPOD
4–19
Once the desired date and time have been entered in this section, the user should then click
[Change Date/Time] as needed to save these changes.
Circuit ID
The user may enter a Circuit ID string of up to 48 characters. Once the desired string had been
entered in this section, the user should then click [Enter Circuit ID] as needed to save this change.
Current Active Firmware Image (read-only)
Identifies the selected Current Active Firmware Image. In this example, Image 2 is the
Current Active Firmware Image.
Next Reboot Image
Using the drop-down menu, select Reboot Image 1 or 2. Press [Submit] when done.
Perform Soft Reboot
Click [Reboot Now] to reboot the LPOD using the Current Active Firmware Image.
Firmware Information (read-only)
Provides the user with a read-only scrollable window to view information about the currently
loaded Bootrom; for Bulk1 and Bulk2, the user can scroll through information of all the constituent
firmware blocks that make up the bulk.
Part Number (read-only)
Provides the user with a read-only scrollable window to view identifying part number information for
the unit in use.
To update the page appearance to the current utility configuration, click [Refresh].
To Next Page
Loading...
