LPOD C- / Ku-Band Outdoor Amplifier/ Block Up Converter (BUC) Revision 3
Appendix B MN-LPOD
B–32
Parameter Type
Command
(Instruction
Code and
Qualifier)
Arguments for
Command or
Response to
Query
Description of Arguments
(Note that all arguments are printable ASCII
characters)
Response to
Command
(Target to Controller)
Query
(Instruction
Code and
qualifier)
Response to
Query
(Target to
Controller)
External
Reference Mute
O
XRM= 1 byte
numeric
Command or Query.
Enables or disables the external reference not present
mute. When the XRM command is enabled the unit will
mute if an external reference oscillator is not detected.
Where:
0 = Disable
1 = *Enable
Example: <1/XRM=1’cr’
Note: To enable this command the internal reference
oscillator option must be installed; otherwise, a mode
error will result. A hardware mute condition generated
by the XRM mute is one of the conditions that can
cause the MUT command to return MUT=2.
XRM=
XRM?
MSK*
XRM?
XRM=x
(See Description
of Arguments for
details)
To Next Page
Loading...
