Condair EL - Page 29

29Operating the control software
Conguration notes:
– the settings of an event remain active up to the next event.
– at least two events must be congured
– the software does not check the plausibility of the timer settings.
Therefore, make sure your settings make sense.
– the On/Off timer overrides the capacity limit timer.
– ON/Off Timers: with this button you can access the settings menu for the
On/Off timer.
With the "Timer" parameter you can activate ("On") or deactivate ("Off")
the On/Off timer.
If the timer is activated, up to eight switching points (Event 1... Event 8)
with different On/Off events can be dened. Each switching point is dened
by a weekday or weekday range, the switching time and the operating
mode of the steam cylinder.
Conguration notes:
– the settings of an event remain active up to the next event.
– at least two events must be congured
– the software does not check the plausibility of the timer settings.
Therefore, make sure your settings make sense.
– the On/Off timer overrides the capacity limit timers.