Condair Mk5 - Electric Installation Procedures

33
5.5 Electric installation
– Allwork concerningtheelectric installationmust beperformedonly byadequately
qualied personnel (electrician or workman with equivalent training). Ascertaining
thequalicationsisthecustomer‘sresponsibility.
– Warning - danger of electric shock! The steam humidier may be connected to
electricmainsonlyafterallinstallationworkhasbeencompleted.
– Please observe all local regulations concerning the electric installation.
– Warning! Electronic components inside the unit are very susceptible to electrostatic
discharges.Fortheprotectionofthesecomponents,measuresmustbetakenduring
allinstallationworktopreventdamagecausedbyelectrostaticdischarge(ESD–protec-
tion)
5.5.1 Electric installation overview
1 Supply heating voltage Up
2 Supply control voltage Uc
 3 InterfaceRS232/RS485
  (option“RS”forMk5Processonly)
 4 Remoteoperatingandfaultindications(option“RFS”)
 5 Externalcontinuouscontroller
 6 Humiditysensor(supplyair/room/exhaust)
7 Safety humidistat
 8 Airowmonitor
 9 Ventilationinterlock
10 Externalsafetycircuit
11 Steamhumidier
12 Internal continuous controller
13 Controlvoltagesupplytosecondunit
14 Controllinetosecondunit
15 Secondunit(from50kg/h)
Condair
Mk5
(A)
Condair
Mk5
(B)