Condair Mk5 - Fault Elimination; Fault Indication and Troubleshooting

58
If the control, after several attempts, fails to solve the problem (number of attempts depends on the
typeofmalfunction)oriftheproblemobstructsfurtheroperation,theheatingvoltageisinterruptedvia
the main contactor. The red LED stays lit and an error message appears in the display alternating
withthenotice“Please turn off unit”.
Example of an “Error” indication
red LED stays lit Message in the display
6.7 Fault elimination
6.7.1 Fault indication
Incaseofmalfunctionduringoperation,thehumidiercontrolcheckswhetherthereisatemporary
problem(e.g.watersupplyinterruptedforashorttime)orwhetheritcanresolvetheproblembytaking
necessary measures. Such malfunctions set the unit into the “Alarm”status(faultelimination).The
red LED ashes and an alarm message appearsinthedisplayalternatingwiththenotice“recover-
ing - please wait”.
Note:Ifthecauseofthemalfunctiondisappearsofitsownaccordorifthecontrolscanrepairthemal-
function,thealarmmessagewillautomaticallyswitchoff.
Example of an “Alarm” indication
red LED ashes Message in the display
please turn
off unit
Error code
Unit designation (A or B)
Note: If the unit is in display or setting level the alarm message
inthedisplaywillbesuppressed.
Error code
Unit designation (A or B)
Note: If the unit is in the display or setting level the error mes-
sageinthedisplaywillbesuppressed.
Error 1A
filling time
Alarm 1A
filling time
recovering
please wait