Condair RM2 - Operation and Commissioning; First-Time Commissioning Procedure

14 Operation
4 Operation
The Condair RM steam humidier may be commissioned and operated only by persons familiar with the
Condair RM steam humidier and adequately qualied. It is the owner’s responsibility to verify proper
qualication of the personnel.
4.1 First-time commissioning
The rst-time commissioning must always be done by a service technician of your Condair representative
or a well trained and authorised person of the customer. Therefore the current manual does not provide
detailed information on this procedure.
The following steps are carried out upon rst-time commissioning in the specied order:
• Inspecting the steam humidier for correct installation.
• Inspecting the electrical installation
• Inspecting the water installation
• Inspecting the steam installation
• Flushing and deaerating the water supply line
• Determining the carbonate hardness of the supply water (by measurement or from the local water
supplier)
• Conguring the control software of the Condair RM via the RM Display (see chapter 6.1).
• Carrying out test runs including checking of the control and monitoring devices.
• Filling out the commissioning record.