Condair RM2 - Service Menu Settings Overview

28 Conguration of Condair RM control software
6.2 Settingsinthe"Service"menu
Accessingthe"Service"menu
• Press the <Menu> button on the top right corner of the display. Then, enter the password "0000" (if
main menu is congured with password protection). The main menu appears.
Note: The password for the user menu can be modied in the "Engineering > Administration >
Password" submenu.
• Select menu item "Service" in the main menu.
• Enter the password ("3562") in the password entry window that appears and conrm. Then, the
"Service" menu appears.
Note: The content of the "Service" menu depends on the selected HVAC application. The following
description of the settings lists all available parameters of the "Service" menu.
SettingparametersMenu"Service"
Error List Shows the list with the current warning and error messages.
ErrorHistory Shows a list of the last 50 warning and error messages.
Steam Generator
Error List Shows the list with the current warning and error messages of the Condair RM steam humidier
ErrorHistory Shows a list of the last 50 warning and error messages of the Condair RM steam humidier
Water Supply Water supply settings for the Condair RM.
– Type: Determining the water supply type
– Tap Water
– RO (Reverse Osmosis Water)
– Filter Cartridge
– Carbonate hardness: Setting the carbonate hardness of the supply water in °dH.
Note: This menu item appears only if the supply water type is set to "Tap Water" or "Filter
Cartridge".
Device Service
View and reset the service values of the Condair RM.
– Service Done: Resetting the maintenance counter after maintenance has been carried out.
– Heat Count: Shows the operating hours extrapolated to 100% steam output
– Next Service: Remaining time in hours until the next maintenance is due.
Filter Cartridge Display, set and reset of the lter cartridge service values.
– Cartridge Size: Determining the size of the lter cartridge used.
– Small
– Large
– Cartridge Replaced: Resetting the maintenance counter after replacing the lter cartridge.
– Water Count: Shows the water consumption in liters.
– Replace in: Remaining water consumption in liters until the next replacement of the lter
cartridge is due.
Hardware Hardware information of the heating channels.
– Hardware:
– Sw. Cycles 1: Number of switching cycles of heating channel No. 1
– Sw. Cycles 2: Number of switching cycles of heating channel No. 2
– Sw. Cycles 3 to Sw. Cycles 5: Not used with Condair RM
– Replace HW 1: Theoretical remaining switching cycles of heating channel No. 1
– Replace HW 2: Theoretical remaining switching cycles of heating channel No. 2
– Replace HW 3 to Replace HW 5: Not used with Condair RM
– Op. Hours HW 1: Current operating hours of the heating channel No. 1
– Op. Hours HW 2: Current operating hours of the heating channel No. 2
– Op. Hours HW 3 to Op. Hours HW 5: Not used with Condair RM
Draining Draining the steam tank.
Device test
– Level Test: Performing a functional test of the level unit.
Restart Restart device software