Condair RM2 - 5.1.1.2 Homescreens With Humidity Sensor And Activated Internal Controller

20 Working with the Display
5.1.1.2 Homescreenswithhumiditysensorandactivatedinternalcontroller
Internal controller enabled, Timer disabled.
Warning triangle (function see chapter 5.2)
Navigation elements (see chapter 5.3)
Operating status eld
Current measured humidity in the air duct/room in % of the relative humidity
Current setpoint in% of the relative humidity
40.9 %
HVAC
60.0 %
Internal controller and Timer enabled.
Note: In timer mode, steam can only be produced if a timer is active and a demand signal from the internal con-
troller is present, otherwise the unit is in standby mode.
40.9 %
60.0 %
Mo 10:00
HVAC
Warning triangle (function see chapter 5.2)
Navigation elements (see chapter 5.3)
Operating status eld.
Current measured humidity in the air duct/room in % of the relative humidity
WeekTimer: Set starting time (weekday/time of day) with timer controlled
humidifying operation.
Note: By pressing this button you access the settings window for determining
the starting time.
Note: After the humidifying operation has started the remaining time until the
end of the humidifying operation is displayed.
Current setpoint in% of the relative humidity