Condair RM2 - Fault Elimination; Important Notes for Fault Elimination

54 Fault elimination
8 Fault elimination
8.1 Important notes on fault elimination
Qualicationofpersonnel
Repair work must be carried out only by qualiedandwelltrainedprofessionals authorised by the
owner.
Repair work relating to the electrical installation must be carried out by an electrician or professionals
authorised by the owner.
General notes
Only use original spare parts from your Condair representative to replace defective parts.
Safety
Before starting repair work on the Condair RM set the unit out of operation and disconnect it from the
mains (see chapter 4.6).
DANGER!
Make sure the Condair RM is separated from the mains (check with voltage tester) and the shut-off
valve in the water supply line is closed.
CAUTION!
The electronic components inside the control compartment of the Condair RM are very sensitive to
electrostatic discharge.
Prevention: Before carrying out any repair work to the electrical or electronic equipment of the Con-
dair RM, appropriate measures must be taken to protect the respective components against damage
caused by electrostatic discharge (ESD protection).