Condair RM2 - Potential Hazards and Prevention

8 For your safety
Danger that may arise from the Condair RMsteamhumidier
DANGER!
Dangerofelectrichazard!
The Condair RMismainspowered.Livepartsmaybeexposedwhentheunitisopen.Touching
live parts may cause severe injury or danger to life.
Prevention: Before carrying out any work set the Condair RM out of operation as described in chapter
4.6 (switch off the unit, disconnect it from the mains and stop the water supply) and secure the unit
against inadvertent power-up.
WARNING!
Hotwatervapour-Dangerofscalding!
The Condair RM produces hot water vapour. There is danger of scalding when coming in con-
tact with hot water vapour.
Prevention: Do not carry out any work on the steam system during operation (steam lines, steam
distributor, etc.). If the steam system is leaky set the Condair RM immediately out of operation as
described in chapter 4.6. Correctly seal the steam system before putting the unit into operation again.
WARNING!
Danger of burning!
During operation the components of the steam system (steam tank, steam distributor, etc.) get
very hot (up to 100 °C). There is danger of burning when touching the hot components.
Prevention: Before carrying out any work on the steam system set the Condair RM out of operation
as described in chapter 4.6, then wait until the components have cooled down sufciently thus pre-
venting danger of burning.
Preventing unsafe operation
If it is suspected that safe operation is no longer possible, the Condair RM should immediately be
shut down and secured against accidental power-up according to chapter 4.6. This can be the case
under the following circumstances:
– if the Condair RM is damaged
– if the electrical installations are damaged
– if the Condair RM is no longer operating correctly
– if connections and/or piping are not sealed
All persons working with the Condair RM must report any alterations to the unit that may affect safety
to the owner without delay.
Prohibitedmodicationstotheunit
Nomodicationsmustbeundertaken on the Condair RM without the express written consent of
Condair Group AG.
For the replacement of defective components use exclusively original accessories and spare parts
available from your Condair representative.