38 | P a g e
Octave (tab-stop)
Choose the Arp Octave: 1-3. This repeats the Arp once in each successive octave. Use the Up/Dn buttons
to move to the Octave value, the value gets underlined. Use the Encoder knob to scroll through the
values.
Gate (tab-stop)
Choose the percentage Gate length: 10%, 30%, 50%, 70%, 90%, RND%. If the length of the gate
percentage gets smaller than the MRCCs ability to calculate (clock tick granularity) it is rounded to the
nearest tick). Use the Up/Dn buttons to move to the Gate choice, the choice gets underlined. Use the
Encoder knob to scroll through the choices.
Rhythm (tab-stop)
Choose the predefined Rhythm A-O. The subscript number is the repeating length of the Rhythm. So if
there is a subscript 9 try using 3,6,9,etc notes in the Arp and listen to the repeating pattern. If you
choose 4 notes then it will take 36 beats (4*9) to repeat. Use the Up/Dn buttons to move to Rhythm
choice, the choice gets underlined. Use the Encoder knob to scroll through the choices.
Clock Source (tab-stop)
Choose the Clock Source: “Int” (MRCC Clock) or any in-port (1-6, A(1-4)-D(1-4), PC(1-12)). If the source
clock is active the source label will be green and a small clock face icon will show. Use the Up/Dn
buttons to move to the Clock Source choice, the choice gets underlined. Use the Encoder knob to scroll
through the choices.
Clock Div (tab-stop)
Choose the Clock Divider: 4:1, 2:1, 1:1, 1:2, 1:4, 1:8 (“T” = triplet). This divides the clock ticks to be a
fraction of or multiple of the clock source beat rate (BPM). Use the Up/Dn buttons to move to the Clock
Div choice, the choice gets underlined. Use the Encoder knob to scroll through the choices.
Source Port (tab-stop)
Choose the source port: (1-6, A(1-4)-D(1-4), PC(1-12)). Use the Up/Dn buttons to move to the Source
Port choice, the choice gets underlined. Use the Encoder knob to scroll through the choices.
Source Chan (tab-stop)
Choose the MIDI source channel: 1-16. Use the Up/Dn buttons to move to the Source Channel choice,
the choice gets underlined. Use the Encoder knob to scroll through the choices.
Destination Port (tab-stop)
Choose the destination port: (1-12, A-D, PC(1-12)). Use the Up/Dn buttons to move to the Destination
Port choice, the choice gets underlined. Use the Encoder knob to scroll through the choices.
Destination Chan (tab-stop)
Choose the MIDI destination channel: 1-16. Use the Up/Dn buttons to move to the Destination Channel
choice, the choice gets underlined. Use the Encoder knob to scroll through the choices.
To Next Page
Loading...
