9 | P a g e
Quick Start
1. Attach the power adapter plug prongs for your country. Plug your MRCC power adapter into an
electrical socket. Plug the USB-C end of the power supply cable into the MRCC USB-C socket on
the side of the unit. Turn on the MRCC. The OLED splash screen should show and the LEDs
should light with a brief prismatic light show.
2. Plug your MIDI controller into any of the in-ports and press the button for that in-port. It should
light green. If you are plugging it into a USB Host port be sure that the virtual in-port cable is set
to #1:
a. You should see the MIDI out-port 1 light green
b. Hold down the USB Host in-port button to see out-ports 2-4 light a dim white. When you
release the in-port button the in-port LED should remain lit green and out-ports 1-4
should not be lit.
3. Plug your synth into any of the out-ports and press the button for that out-port. It lights blue
when selected, and becomes dimmer when it is routed and another output is selected.
If the out-port is the USB PC port be sure that the virtual out-port cable is set to #1 (see step 2).
4. The route is made. Make sure your controller and synth are set to the same MIDI channel. The
ROUTING screen will show you the inbound MIDI messages and channel if you’re not sure. Of
course, you can map the channel but you’ll need to read a bit more to learn how to do that! ☺
Happy ROUTING!!!
To Next Page
Loading...
