8 | P a g e
Thank you for purchasing the MRCC from Conductive Labs!
Introduction
With your MRCC from Conductive Labs you can route your controllers to your synths with a touch of a
button; the MRCC never needs to be connected to a PC for configuration. The four USB host ports enable
you to use all those cool USB only (USB MIDI Class Compliant) MIDI controllers that previously needed to
be plugged into a PC to work. Imagine triggering your favorite drum machines with button pads or
tweaking synth parameters from the knobs on your keyboard controllers with no PC in sight!
On the following pages are all the nuts and bolts of the MRCC. In addition to the simple button press
routing there is USB virtual cable routing and some extras and tools that will be explained in this manual.
For support please use our forum at: https://www.conductivelabs.com/forum.
The MRCC (MIDI Router Control Center) is a front panel configurable MIDI router which means no PC is
required to configure the routings, message filters, or message modifiers.
The MRCC can be used in a variety of ways. For example:
• Connection between MIDI controllers and synths.
• A complex studio setup with MRCC as the hub, routing MIDI messages to several synths while
transposing inbound keyboard notes, and driven by multiple MIDI controllers.
• With the “MRCC Remote 7” accessory, 5 MIDI out ports can be accessed via a single CAT5 shielded
cable of up to 50’ away.
To Next Page
Loading...
