50 | P a g e
MRCC-to-MRCC + Remote7 connection
It is possible to have both a MRCC-to-MRCC connection at the same time as a Remote7 connection. It
requires a special RJ45 “splitter” where the on the MRCC-to-MRCC side of the splitter only connection
pins 4 & 5 (middle tow) are present and all the connection pins on the Remote7 side are present. All
RJ45 cables should be as described above. Note that the R7 status on Setting Menu2 will automatically
turn blue and switched into “Copy 1-5” mode.
To Next Page
Loading...
