Consilium CFD5000 T / CM4.3 - Table of Contents

Table of contents
1 Introduction....................................................................................... 1
1.1 Symbols used in the manual ............................................................. 1
1.2 Standards and Certifications ............................................................ 3
2 Safety Considerations ....................................................................... 5
2.1 If a Fire or Fault Alarm is Flashing on the Control Panel ............ 5
2.1.1 In Case of a Fire Alarm.................................................................. 5
2.1.2 In Case of a Pre-Alarm .................................................................. 5
2.1.3 In Case of a Fault Alarm................................................................ 5
2.1.4 Further Instructions........................................................................ 5
2.2 Precautionary Measures ................................................................... 6
3 Maintenance...................................................................................... 7
3.1 Scheduled Maintenance.................................................................... 7
3.2 Proof Test........................................................................................... 8
3.3 Periodic BIST.................................................................................... 8
3.4 Testing (Control Panel CM 4.3)........................................................ 9
3.4.1 Test Mode Overview...................................................................... 9
3.4.2 Testing a Fire-Detecting Zone ....................................................... 9
3.4.3 Recommended Test Equipment and Procedures............................ 10
3.4.4 Reset Test Mode............................................................................. 14
3.4.5 Test Fault Conditions ..................................................................... 14
3.4.6 Test the Control Panel Display ...................................................... 15
3.5 Cleaning of Fire Detectors ............................................................... 16
3.5.1 Prior to Cleaning ............................................................................ 16
3.5.2 Smoke Detector.............................................................................. 16
3.5.3 Aspirating Smoke Detector............................................................ 16
3.5.4 Heat Detector ................................................................................. 17
3.5.5 Flame Detector............................................................................... 17
4 Replacement and Service.................................................................. 19
4.1 Prerequisites for Replacement.......................................................... 19
4.2 Replacing Loop Units........................................................................ 20
4.2.1 Replacing Fire Detectors................................................................ 20
4.2.2 Replacing Aspirating Smoke Detector CS-ASP ............................ 20
4.2.3 Setting the Address on Loop Units ................................................ 22
4.3 After Replacement............................................................................. 23