Consilium CFD5000 T / CM4.3 - Configuration, Submenu

Service & Maintenance Manual 8Appendix A
5100614_CFD5000 T - CM4.3_Service & Maintenance Manual_T_EN_2020_E
57
•
Press 0 to send a list with details for the selected loop unit to a connected
printer.
•
Press "1 Update list" to update the answering side status when A/B list shows
OK(?/?).
For instructions, see Cable Break, page 27 or Short Circuit, page 28.
8.1.7 Configuration, Submenu 6
Hint!
For further instructions, refer to Downloading a Configuration File to a USB
Memory Stick and Uploading an Configuration File from a USB Memory Stick,
page 33.
The following alternatives can be found in the Configuration submenu:
1 Reload configuration/Reboot this module
Reload the configuration when a new updated configuration file has been
downloaded to the system. The operation will reboot this Control Module only.
2 Load configuration from USB Memory
Download a new configuration file from a suitable USB memory stick.
3 Save configuration to USB Memory
Copy the existing configuration file to a suitable USB memory stick.
4 Save changes to configuration
The Save changes to configuration menu is used to keep the changes made to the
system configuration from the control panel (if allowed in the FDS).
NOTE!
The changes are not permanently saved in the configuration file until
this command is performed.
5 Remove configuration
Select and remove files from a list of configuration files in the system.
6 Synchronise system configuration
CAUTION!
It is highly recommended to backup the configuration file before
continuing (see Downloading a Configuration File to a USB Memory
Stick, page 33).
Use this command to synchronise the configuration files in the system.
7 Reboot system (this module excluded)
The operation will reboot the system with this Control Module excluded.