Consilium CFD5000 T / CM4.3 User Manual

3Maintenance Service & Maintenance Manual
14
5100614_CFD5000 T - CM4.3_Service & Maintenance Manual_T_EN_2020_E
Figure 2. Testing CS-MCP HD and CS-MCP HD Ex
1 Insert the key into the test hole.
The test hole is situated on the bottom right hand side of the glass cover.
2 Turn the key in a clockwise direction (approximately 60°).
This will simulate the breaking of the glass.
3 Release the key to reset the call point.
4 Check and reset any fault codes generated from the testing.
3.4.4 Reset Test Mode
NOTE!
After testing is completed, return the tested zone to its normal condition.
Before exiting test mode, make sure there are no detectors or manual call points in
alarm condition.
The tested zone will automatically return to normal operation after two hours if no
manual reset have been performed.
To reset test mode:
1 The zones in test mode are listed in the Disablement List, found under: Menu » 3
Disablements » 2 List disablements.
2 Choose the zone in the disablement list and then press .
3.4.5 Test Fault Conditions
3.4.5.1 About Fault Conditions
The Fire detection central continuously monitors the system components and
reports any fault condition on the control panel with both visual and audible
indicators.
It is possible to test fault alarm indications by following the procedures below:
NOTE!
The fault condition may be reset only after the cause of the fault has been remedied.
Hint!
Please follow the recommendations for remedy in the Fault code list.

Consilium CFD5000 T / CM4.3 Specifications

General

Brand	Consilium
Model	CFD5000 T / CM4.3
Category	Measuring Instruments
Language	English