4. BIOS Setup
Security Window
Set Supervisor Password : [Enter]
Set User Password : [Enter]
Supervisor Password Is : Clear
User Password Is : Clear
Password on boot : [Disabled]
Clear All Passwords : [Enter]
F1 Help
↓
Select Item -/+ Change Values F9 Setup Defaults
Esc Exit
←→
Select Menu Enter Select Sub-Menu F10 Save and Exit
PhoenixBIOS Setup Utility
Main Advanced Security Power PC_Health Boot Exit
Item Specific Help
Supervisor Password
controls access to the
setup utility.
↓
Figure 4.6. Security Window (Factory Settings)
Set Supervisor Password : Specify whether or not to require a
password during setup. If a password is
set, "Supervisor Password is" is enabled.
Supervisor mode allows all settings to
be set.
Set User Password : Specify whether or not to require a
password during setup. If a password is
set, "User Password is" is enabled. User
mode allows only the date and time to
be set.
Password on boot : Specify whether or not to require a
password when booting.
Clear All Password : Both passwords can be erased by
Supervisor.
Note!
Once a password is registered, even the password function itself
cannot be cancelled without the password. Passwords should be
handled with great care.
40
User’s Manual