Manuale di Istruzioni
Instruction Manual
Rev.1 EN 23/08/2018
109
6. DIAGNOSTICS & TROUBLESHOOTING
The present chapter provides information on the diagnostic programs present in the
system and on the troubleshooting of the most common problems.
Depending on the problem encountered, the troubleshooting is carried out by dividing the
system into functional blocks.
WARNING:
Before opening/removing the covers, disconnect the mains supply to the device and wait
at least 5 minutes.
WARNING:
Covers/doors can only be removed/opened by maintenance people, by using relevant
tools/buttons. These tools and buttons are for the use of maintenance people only. Never
leave them attached to the unit as this may endanger operator safety. After performing
maintenance/repair, make sure that all covers/doors are properly closed and locked.
WARNING:
All safety devices must be functional at all times. Damaged protective covers or devices
must be replaced immediately. When safety components are replaced, the protective
devices are to be properly attached and tested. Any manipulation of the safety devices
endangers the operating personnel.
WARNING:
Refer to qualified service organization authorized by CONTROLS to carry out the service
maintenance actions described in the chapter “Diagnostic and Troubleshooting”.
CONTROLS has not to be held responsible for damages to the equipment and/or injuries
to personnel in case the above is not strictly followed.
To Next Page
Loading...
Need help?
General
