Controls WIZARD 2 50-C92AXX User Manual

Manuale di Istruzione
Instruction Manual
23/08/2018 Rev.1 EN
84
5.1 Operator’s preventive maintenance
The inspections made directly by the operator are the following:
Action Who When
Check to ensure that there is no
external damage to the equipment,
which could jeopardise the safety of
use
Operator Before every working session
Clean and dry platens, distance
piece and ram of the frame from the
sample debris
Operator At the end of each working
session
Gen
eral inspection
Operator
Weekly
Check the status of the hydraulic
tubes against leakages and damages
Operator Weekly
Check status of the safety devices:
EMERGENCY BUTTON, max.
pressure valve, piston over travel
switch and relevant cable on the
frame, front door and rear
transparent guard on the frame
(refer to chapter 5.1.1 for their
identification)
Operator Weekly
Check status and functioning of the
operator's commands
Operator Weekly
Check the level of the oil in the
tank
(
see chapter
5.1.2
)
Operator Monthly
Check that all label and rating
plates are intact and properly
attached
Operator Monthly
NOTE:
Previous table indicates also the maintenance actions to be performed on the frames
normally connected to the control console.


Controls WIZARD 2 50-C92AXX Specifications

General

Brand	Controls
Model	WIZARD 2 50-C92AXX
Category	Laboratory Equipment
Language	English