Manuale di Istruzioni
Instruction Manual
Rev.1 EN 23/08/2018
83
WARNING:
Due to the high pressure inside the hydraulic circuit (up to 650 bars) only tubes approved
by CONTROLS can be used. CONTROLS will not be responsible for damages to the
equipment or personnel injures in case of use of improper material and/or operations not
carried out by authorized technical personnel.
WARNING:
For continued fire protection, replace fuses with same type and rating. Also, in case of
failure, components may only be replaced by using original spare parts. It is in the
responsibility of the purchaser to ensure that fire prevention policies are properly
implemented according to the CE provisions.
WARNING:
Avoid pouring water, even accidentally, or other liquids into the device, as this could
cause short circuits. Before cleaning the device, disconnect it from the mains line.
WARNING:
To avoid direct contact with the oil of the hydraulic circuit, always wear protective gloves
while performing the checking.
To Next Page
Loading...