Manuale di Istruzione
Instruction Manual
23/08/2018 Rev.1 EN
38
3. INSTALLATION
The instructions indicated in this chapter enable you to perform a correct installation and
interfacing in order to grant a regular operation of the equipment.
Included are initial inspection procedure, power requirements and instructions for
installing the unit.
The information in this chapter is intended for authorized service-trained personnel.
CONTROLS can supply the assistance and the necessary technical advice for pre-
installation, all the pre-installation phases are at the purchaser’s charge and must be
performed complying with the indications given below.
WARNING:
When operating with the covers open/removed and the unit is attached to the mains line,
care must be taken as high voltage is present in some parts of the unit (e.g. electrical
panel). Only authorized and qualified service technicians are allowed to open /remove
covers.
WARNING:
All safety devices must be functional at all times. Damaged protective covers or devices
must be replaced immediately. When safety components are replaced, the protective
devices are to be properly attached and tested. Any manipulation of the safety devices
endangers the operating personnel.
WARNING:
To avoid direct contact with the oil of the hydraulic circuit, always wear protective gloves
while performing the checking.
To Next Page
Loading...
Need help?
General
