Manuale di Istruzioni
Instruction Manual
Rev.1 EN 23/08/2018
17
The following table lists those parts of the equipment that may present some residual
risks for the safety of the personnel if the instructions provided in this manual are not
duly followed.
Personnel Area with residual risks
Operator The sample during load-unloading phase from the frame, due to its weight
and sharp surfaces. Use suitable personal protection devices (e.g. gloves,
The distance pieces and platens during the installation phase on the frame,
due to their weight. Use suitable personal protection devices (e.g. gloves,
The area around the frame during the execution of the test, in case of test on
explosive samples and with the front and rear fragment guards not in place.
The gap between the sample and the upper platen on the frame during the
compression phase, although the maximum speed is very low (max. 40
Technical personnel
Area around the hydraulic tubes, due to the high pressure of the oil, in case
the tubes are damaged or not properly attached
round compartments closed by removable panels
Areas around compartments that contain electrical parts
For continued fire protection, replace fuses with same type and rating. Also,
in case of failure, components may only be replaced by using original spare
parts. It is in the responsibility of the purchaser to insure that fire prevention
policies are properly implemented according to the CE provisions.
Personnel
responsible of
transportation and
moving of the
Raising and moving of the equipment from the wooden crate must be
performed by people properly trained and equipped with suitable personal
protection devices (e.g. gloves, helmet, etc.). Failure to follow the
instructions above may endanger the personnel involved.
To Next Page
Loading...
Need help?
General
