Manuale di Istruzioni
Instruction Manual
Rev.1 EN 23/08/2018
21
WARNING:
For continued fire protection, replace fuses with same type and rating. Also, in case of
failure, components may only be replaced by using original spare parts. It is in the
responsibility of the purchaser to ensure that fire prevention policies are properly
implemented according to the CE provisions.
WARNING:
Avoid pouring water, even accidentally, or other liquids into the device, as this could
cause short circuits. Before cleaning the device, disconnect it from the mains line.
WARNING:
Refer to qualified service organization authorized by CONTROLS to carry out the
maintenance actions described in the chapter “Authorized service engineer maintenance
action”. CONTROLS has not to be held responsible for damages to the equipment and/or
injuries to personnel in case the above is not strictly followed.
WARNING:
The CALIBRATION menu should only be entered when the calibration needs to be
changed. Do not enter into this menu for any other reason. Before entering the
CALIBRATION menu it is vital to carefully read and understand the procedure
described hereunder. If any doubts remain, contact CONTROLS service department for
further clarification.
CONTROLS will accept no responsibility for any inconvenience caused by wrongful
calibration.
WARNING:
Do not use the MEMORY RESET function unless authorized by CONTROLS Service
department. CONTROLS will not be held responsible for damages to the equipment
and/or injuries to personnel in case the above is not strictly followed.
To Next Page
Loading...
Need help?
General
