|
45
OPERATING INSTRUCTIONS
2. Turn the nut counter-clockwise until the
wheel can be removed from the frame or
front forks without any great eort.
Should the nut come right o the screw,
please ensure that the little springs do
not get lost.
3. On saddle stem quick release levers: To
loosen, instead of the nut, turn the bolt
with the Allen key head itself counter-
clockwise.
Tightening: Reverse the procedure
1. If the quick release lever was completely
removed then push it from the left (in the
direction of travel) through the hub.
2. Place the springs and the nuts on the bolt.
Turn the right end now protruding from
the hub and the nut clockwise.
•
The ends of the springs with the smaller
diameter always face the hub.
•
On saddle stem locking quick-releases,
instead of the nut there is a bolt head with
an Allen key hexagon insert head.
Special types:
Some road wheels are xed with oating axles or
a combination of oating axle and quick-release
lever or are equipped with other axle clamping
systems. Please refer to the accompanying inst-
ructions on the handling of these parts provided
by the suspension fork manufacturer and/or
consult your specialist dealer.
To open the quick release:
1. Push the excentric lever away from the
hub. It can now be rotated 180° around
its axis.
To Next Page
Loading...
