46
|
OPERATING INSTRUCTIONS
3. On saddle stem quick release levers:
instead of the nut, turn the bolt with the
Allen key head itself clockwise.
4. Tilt the excentric lever so that it appro-
ximately forms the extension of the hub
axis Hold the lever in this position.
5. Now turn the nut or the Allen key bolt
head until the excentric lever, when
turned around its bearing more than 90°
to meet slight resistance (it now forms an
approximately straight line extension of
the hub axis.
6. Now press the lever through a further 90°
until it reaches its end stop.
Risk of Personal Injury and Material
Damage!
Incorrect operation of the brakes can lead
to dangerous riding conditions, falling,
accidents and material damage.
If the lever is pressed into its stop po-
sition, the wheel is not secured tightly
enough and can become displaced during
riding or loosen.
There is a danger of falling.
•
Open the lever again and turn the nut
counter-clockwise again as necessary.
•
Check that the wheels are seated rmly as
described in Chapter 7.1
To Next Page
Loading...
