60
|
OPERATING INSTRUCTIONS
1. b) Inserting the front wheel:
•
Lift up the bike by the handlebars.
•
Place the front wheel under the front forks
dropouts
•
For disc brakes: Attach the wheel in such a
way that the disc brakes are able to move
freely between the brake pads.
•
Carefully lower the forks until the axle is
ush at the dropout stops on the right and
left sides.
2. Tighten the wheel hubs.
•
When tightening with quick releases: see
Chapter 8.8.
•
With other types of clamping: tighten
the hubs as per the accompanying parts
instructions.
3. a) Close rim brakes
on cable brakes:
•
Press the brake shoes together.
•
Insert the cable in the yoke.
3. b) Hydraulic rim brakes: tting is as remo-
val only in reverse sequence.
•
Place the brake booster on the lead screws
•
Insert any distance washers in the correct
position and place the brake on the brake
bosses.
•
Swivel the locking lever so that the brake is
xed in place again.
4. Please ensure that the brake blocks
correctly cover the rim shoulder when
operated.
To Next Page
Loading...
