Cutter
1
2
Clean the cutter
by using compressed air.
Disconnect the power supply cable and open all the
device covers (see previous paragraphs).
ATTENTION:
Do not use alcohol, solvents, or hard brushes.
Do not let water or other liquids get inside the machine.
To remove paper scraps, use tweezers or compressed air.
ON
Alcohol, solvent
Case
1
Disconnect the power supply cable.
2
To clean the device,
use compressed air or a soft cloth.
ATTENTION:
Do not use alcohol, solvents, or hard brushes.
Do not let water or other liquids get inside the machine.
ON
Alcohol, solvent
107
To Next Page
Loading...
