CVC TECHNOLOGIES, INC. CVC 310 OPERATION MANUAL
The equipment should be serviced by qualified personnel when the equipment
does not appear to operate normally or exhibits a marked change in
performance.
Do not attempt to clean, inspect and maintain the equipment beyond that
described in this instruction manual. All other servicing should be referred to
your service dept. of your nearest sales distributor.
Always wear personal protective clothing, able to resist possible dangers. Do
not wear any loose hanging clothing or accessories. Cover or put up long hair.
Do not apply excessive force to the electrical, mechanical or pneumatic control
elements.
Always ensure whether no moving parts of the equipment are blocked or
obstructed by any form of waste materials.
Cleaning, inspection and maintenance should only be carried out by fully
qualified and authorized maintenance personnel.
During cleaning or maintenance always observe all local and in-door valid labor
protection, safety and environmental regulations.
Make sure all cabinets and maintenance flaps/doors are fitted in their correct
position when no longer carrying out cleaning, inspection or maintenance.
When during cleaning or maintenance no power is required, always switch OFF
and padlock the main power switch.
The electronic equipment inside the electronics cabinet(s) may still be live even
when the main power switch is switched OFF ! Always remove the power supply
cord from the outlet prior to cleaning, inspection or maintenance work. Always
keep the Power Box closed unless required for service purposes.
3 - 6
To Next Page
Loading...