xStack
®
DES-3500 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
141
DHCP Local Relay Settings
The DHCP Local Relay Settings are used to request packets from the Client to the Server. As a result of the customer’s
networking environment, DCHP Local Relay is implemented so that it is independent from the original behavior of DHCP relay.
The DHCP Local Relay is also independent from the option82 module in the forwarding way and the content of DHCP request
packets from Client to Server.
To enable and configure DHCP Local Relay Global Settings on the Switch, click Configuration > Layer 3 IP Networking >
DHCP/BOOTP Relay > DHCP Local Relay Settings:
Figure 6- 125. DHCP Local Relay Settings window
The following parameters may be configured or viewed.
Parameter Description
DHCP/BOOTP Local
Relay Operation State
Used to Enable or Disable the DHCP/BOOTP Local Relay Operation State.
VLAN Name
This is the VLAN Name that identifies the VLAN the user wishes to modify the
DHCP/BOOTP Local Relay Settings for.
VID List
This is the VID List that identifies the VLAN the user wishes to modify the DHCP/BOOTP
Local Relay Settings for.
State
Enable or Disable the DHCP/BOOTP Local Relay Settings state.
Click Apply to implement changes made.
To Next Page
Loading...
Need help?
General