xStack
®
DES-3500 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
235
Reset Config
The Reset Config option will reset all of the Switch's configuration parameters to their factory defaults, without saving these
default values to the Switch's non-volatile RAM. If the Switch is reset with this option enabled, and Save Changes is not executed,
the Switch will return to the last saved configuration when rebooted.
Figure 9- 12. Reset Config window
Reboot Device
The following window is used to restart the Switch.
All of the configuration information entered from the last time Save Changes was executed will be lost. Click the Reboot button
to restart the Switch.
Figure 9- 13. Reboot window
Logout
Use the Logout page to logout of the Switch's Web-based management agent by clicking on the Log Out button.
Figure 9- 14. Logout Web Setup window
To Next Page
Loading...
Need help?
General