xStack
®
DES-3500 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
40
dynamically, one end of the connection must have "active" LACP ports (see above).
After setting the previous parameters, click Apply to allow your changes to be implemented. The LACP Port Table shows which
ports are active and/or passive.
MAC Notification
MAC Notification is used to monitor MAC addresses learned and entered into the forwarding database.
MAC Notification Global Settings
To globally set MAC notification on the Switch, open the following window by opening Configuration > MAC Notification >
MAC Notification Global Settings:
Figure 6- 12. MAC Notification Global Settings window
The following parameters may be modified:
Parameter Description
State
Enable or disable MAC notification globally on the Switch
Interval (sec)
The time in seconds between notifications.
History size
The maximum number of entries listed in the history log used for notification. Up to 500 entries
can be specified.
To Next Page
Loading...
Need help?
General