xStack
®
DES-3500 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
143
Re Init Delay (1-
10)
The LLDP reinitialization delay interval is the minimum time that an LLDP port will wait before
reinitializing after receiving an LLDP disable command. To change the LLDP Reinit Delay, enter
a value in seconds (1 to 10).
TX Delay (1-8192)
LLDP TX Delay allows the user to change the minimum time delay interval for any LLDP port
which will delay advertising any successive LLDP advertisements due to change in the LLDP
MIB content. To change the LLDP TX Delay, enter a value in seconds (1 to 8192).
Notification
Interval (5-3600)
LLDP Notification Interval is used to send notifications to configured SNMP trap receiver(s) when
an LLDP change is detected in an advertisement received on the port from an LLDP neighbor.
To set the LLDP Notification Interval, enter a value in seconds (5 to 3600).
Click Apply to implement changes made.
To Next Page
Loading...
Need help?
General