xStack
®
DES-3500 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
177
Figure 7- 33. Enable Method List Settings window
To delete an Enable Method List defined by the user, click the X under the Delete heading corresponding to the entry desired to be
deleted. To modify an Enable Method List, click on its hyperlinked Method List Name. To configure a Method List, click the Add
button.
Both actions will result in the same window to configure:
Figure 7- 34. Enable Method List - Edit window
Figure 7- 35. Enable Method List - Add window
To define an Enable Login Method List, set the following parameters and click Apply:
Parameter Description
Method List Name
Enter a method list name defined by the user of up to 15 characters.
Method 1, 2, 3, 4
The user may add one, or a combination of up to four of the following authentication methods to
this method list:
• local_enable - Adding this parameter will require the user to be authenticated using
the local enable password database on the Switch. The user in the next section
entitled Local Enable Password must set the local enable password.
• none - Adding this parameter will require an authentication to access the Switch.
To Next Page
Loading...
Need help?
General