D-Link DXS-3326GSR - Traffic Segmentation

DXS-3326GSR Gigabit Layer 3 Switch
Figure 6- 46. User Priority Configuration window
Once you have assigned a priority to the port groups on the Switch, you can then assign this Class to each of the eight
levels of 802.1p priorities. Click Apply to set your changes.
Traffic Segmentation
Traffic segmentation is used to limit traffic flow from a single port to a group of ports on either a single switch (in
standalone mode) or a group of ports on another switch in a switch stack (Single IP). This method of segmenting the flow
of traffic is similar to using VLANs to limit traffic, but is more restrictive. It provides a method of directing traffic that
does not increase the overhead of the Master switch CPU.
In the Configuration folder open the QoS folder and click Traffic Segmentation, to view the window shown below.
88