DXS-3326GSR Gigabit Layer 3 Switch
group may be changed dynamically as needs require. In order to utilize the ability to
change an aggregated port group, that is, to add or subtract ports from the group, at
least one of the participating devices must designate LACP ports as active. Both
devices must support LACP.
Passive - LACP ports that are designated as passive cannot initially send LACP
control frames. In order to allow the linked port group to negotiate adjustments and
make changes dynamically, one end of the connection must have "active" LACP
ports (see above).
After setting the previous parameters, click Apply to allow your changes to be implemented. The LACP Port Table
shows which ports are active and/or passive.
MAC Notification
MAC Notification is used to monitor MAC addresses learned and entered into the forwarding database.
MAC Notification Global Settings
To globally set MAC notification on the Switch, open the following window by opening the MAC Notification folder and
clicking the MAC Notification Global Settings link:
Figure 6- 12. Current MAC Notification Global Setting window
The following parameters may be modified:
Parameter Description
State
Enable or disable MAC notification globally on the Switch
Interval (1-
2147483647sec)
The time in seconds between notifications.
History size (1-500)
The maximum number of entries listed in the history log used for notification. Up to
500 entries can be specified.
MAC Notification Port Settings
To change MAC notification settings for a port or group of ports on the Switch, click Port Settings in the MAC
Notification folder, which will display the following window:
47
To Next Page
Loading...
