DXS-3326GSR Gigabit Layer 3 Switch
Section 5
Introduction to Web-based Switch Configuration
Login To Web manager
Web-Based User Interface
Basic Setup
Reboot
Basic Switch Setup
Network Management
Switch Utilities
Network Monitoring
IGMP Snooping Status
All software functions of the DXS-3326GSR can be managed, configured and monitored via the embedded web-based
(HTML) interface. The Switch can be managed from remote stations anywhere on the network through a standard browser
such as Opera, Netscape Navigator/Communicator or Microsoft Internet Explorer. The browser acts as a universal access
tool and can communicate directly with the Switch using the HTTP protocol.
The Web-based management module and the Console program (and Telnet) are different ways to access the same internal
switching software and configure it. Thus, all settings encountered in web-based management are the same as those found
in the console program.
Login to Web Manager
To begin managing your Switch, simply run the browser you have installed on your computer and point it to the IP address
you have defined for the device. The URL in the address bar should read something like: http://123.123.123.123, where the
numbers 123 represent the IP address of the Switch.
NOTE: The Factory default IP address for the Switch is 10.90.90.90.
In the page that opens, click on the following Login button:
Figure 5- 1. Login button
This opens the management module's user authentication dialog box, as seen below.
29
To Next Page
Loading...
