D-Link DXS-3326GSR - Authenticator Statistics

DXS-3326GSR Gigabit Layer 3 Switch
Backend State
The Backend Authentication State can be Request, Response, Success, Fail, Time-
out, Idle, Initialize, or N/A. N/A (Not Available) indicates that the port's authenticator
capability is disabled.
Port Status
Controlled Port Status can be Authorized, Unauthorized, or N/A.
Authenticator Statistics
This table contains the statistics objects for the Authenticator PAE associated with each port. An entry appears in this table
for each port that supports the Authenticator function. To view the Authenticator Statistics, click Monitoring > Port
Access Control > Authenticator Statistics.
Figure 10- 2 . Show Authenticator Statistics window 4
The user can specify a switch in a switch stack using that switch’s Unit ID by using the pull down menu in the top left hand
corner. The user may also select the desired time interval to update the statistics, between 1s and 60s, where “s” stands for
seconds. The default value is one second.
The following fields can be viewed:
Parameter Description
Port
The identification number assigned to the Port by the System in which the Port
resides.
Frames Rx
The number of valid EAPOL frames that have been received by this Authenticator.
Frames Tx
The number of EAPOL frames that have been transmitted by this Authenticator.
Rx Start
The number of EAPOL Start frames that have been received by this Authenticator.
Tx ReqId
The number of EAP Req/Id frames that have been transmitted by this Authenticator.
Rx LogOff
The number of EAPOL Logoff frames that have been received by this Authenticator.
Tx Req
The number of EAP Request frames (other than Rq/Id frames) that have been
transmitted by this Authenticator.
225