DXS-3326GSR Gigabit Layer 3 Switch
255)
the user. The user may set a time between 0 and 255 seconds. The default
setting is 30 seconds.
User Attempts (1-255)
This command will configure the maximum number of times the Switch will accept
authentication attempts. Users failing to be authenticated after the set amount of
attempts will be denied access to the Switch and will be locked out of further
authentication attempts. Command line interface users will have to wait 60
seconds before another authentication attempt. Telnet and Web users will be
disconnected from the Switch. The user may set the number of attempts from 1 to
255. The default setting is 3.
Click Apply to implement changes made.
Application Authentication Settings
This window is used to configure switch configuration applications (console, Telnet, SSH, web) for login at the user level
and at the administration level (Enable Admin) utilizing a previously configured method list. To view the following
window, click Security Management > Access Authentication Control > Application Authentication Settings:
Figure 8- 6. Application's Authentication Settings window
The following parameters can be set:
Parameter Description
Application
Lists the configuration applications on the Switch. The user may configure the
Login Method List and Enable Method List for authentication for users utilizing the
Console (Command Line Interface) application, the Telnet application, SSH, and
the Web (HTTP) application.
Login Method List
Using the pull down menu, configure an application for normal login on the user
level, utilizing a previously configured method list. The user may use the default
Method List or other Method List configured by the user. See the Login Method
Lists window, in this section, for more information.
Enable Method List
Using the pull down menu, configure an application for normal login on the user
level, utilizing a previously configured method list. The user may use the default
Method List or other Method List configured by the user. See the Enable Method
Lists window, in this section, for more information
Click Apply to implement changes made.
Authentication Server Group
This window will allow users to set up Authentication Server Groups on the Switch. A server group is a technique used to
group TACACS/XTACACS/TACACS+/RADIUS server hosts into user-defined categories for authentication using
method lists. The user may define the type of server group by protocol or by previously defined server group. The Switch
has four built-in Authentication Server Groups that cannot be removed but can be modified. Up to eight authentication
server hosts may be added to any particular group.
175
To Next Page
Loading...
