DXS-3326GSR Gigabit Layer 3 Switch
To view the following window, click Security Management > Access Authentication Control > Authentication Server
Group:
Figure 8- 7. Authentication Server Group Settings window
This window displays the Authentication Server Groups on the Switch. The Switch has four built-in Authentication Server
Groups that cannot be removed but can be modified. To modify a particular group, click its hyperlinked Group Name,
which will then display the following window.
Figure 8- 8. Add a Server Host to Server Group (xtacacs) window
To add an Authentication Server Host to the list, enter its IP address in the IP Address field, choose the protocol associated
with the IP address of the Authentication Server Host and click Add to Group to add this Authentication Server Host to
the group.
To add a server group other than the ones listed, click the Add button on the Authentication Server Group Settings
window, revealing the following window to configure.
Figure 8- 9. Authentication Server Group Table Add Settings window
Enter a group name of up to 15 characters into the Group Name field and click Apply. The entry should appear in the
Authentication Server Group Settings window.
176
To Next Page
Loading...
