DXS-3326GSR Gigabit Layer 3 Switch
In configuring the user-defined protocol, the administrator must make sure that the pre-defined user type header does not
match any other type header. A match may cause discrepancies within the local network and failure to define the VLAN to
forward packets to.
Static VLAN Entry
In the Configuration folder, open the VLAN folder and click the Static VLAN Entry link to open the following window:
Figure 6- 34. Current 802.1Q Static VLANs Entries window
This window lists all previously configured VLANs by VLAN ID and VLAN Name. To delete an existing 802.1Q VLAN,
click the corresponding
button under the Delete heading.
To create a new 802.1Q VLAN, click the Add button in the window above. A new window will appear, as shown below,
to configure the port settings and to assign a unique name and number to the new VLAN. See the table below for a
description of the parameters in the new window.
Figure 6- 35. 802.1Q Static VLANs window
To return to the Current 802.1Q Static VLANs Entries window, click the Show All Static VLAN Entries
link. To change
an existing 802.1Q VLAN entry, click the Modify button of the corresponding entry you wish to modify. A new window
will appear to configure the port settings and to assign a unique name and number to the new VLAN. See the table below
for a description of the parameters in the new window.
71
To Next Page
Loading...
