D-Link DXS-3326GSR - STP Port Settings

DXS-3326GSR Gigabit Layer 3 Switch
Figure 6- 25. STP Instance Table window
The following information is displayed:
Parameter Description
Instance Type
Displays the instance type(s) currently configured on the Switch. Each instance type
is classified by an MSTI ID. CIST refers to the default MSTI configuration set on the
Switch.
Instance Status
Displays the current status of the corresponding MSTI ID.
Instance Priority
Displays the priority of the corresponding MSTI ID. The lowest priority will be the root
bridge.
Click Apply to implement changes made.
To make changes to entries on the STP Instance Table window, click Modify:
Figure 6- 26. Instance ID Settings window
The following information is displayed:
Parameter Description
MSTI ID
Enter the Instance Type, which is classified by an MSTI ID.
Type
Set Priority Only is selected to create a new priority. No other choices are available for
this field.
Priority (0-61440)
Select a value between 0 and 61440 to specify the priority for a specified MSTI for
forwarding packets. The lower the value, the higher the priority. This entry must be
divisible by 4094
STP Port Settings
STP can be set up on a port per port basis. To view the following window click Configuration > Spanning Tree > STP
Port Settings:
60