DXS-3326GSR Gigabit Layer 3 Switch
To search for OSPF neighbors, enter an IP address and click Find. Valid OSPF neighbors will appear in the OSPF
Neighbor Table below.
OSPF Virtual Neighbor Table
This table can be found in the OSPF Monitor folder by clicking on the Browse OSPF Virtual Neighbor Table link. This
table displays a list of Virtual OSPF Neighbors of the Switch. The user may choose to specifically search a virtual neighbor
by using one of the two search options at the top of the window. These are described below:
Parameter Description
Transit Area ID
Allows the entry of an OSPF Area ID − previously defined on the Switch − that allows
a remote area to communicate with the backbone (area 0). A Transit Area cannot be
a Stub Area or a Backbone Area.
Neighbor ID
The OSPF router ID for the remote router. This IP address uniquely identifies the
remote area’s Area Border Router.
Figure 10- 3 . OSPF Virtual Neighbor Table window 6
DVMRP Monitor
This menu allows the DVMRP (Distance-Vector Multicast Routing Protocol) to be monitored for each IP interface defined
on the Switch. This folder, found in the Monitoring folder, offers three windows for monitoring: Browse DVMRP
Routing Table, Browse DVMRP Neighbor Address Table and Browse DVMRP Routing Next Hop Table.
Information on DVMRP and its features in relation to the DXS-3326GSR can be found in Section 6, under IP Multicast
Routing Protocol.
Browse DVMRP Routing Table
Multicast routing information is gathered and stored by DVMRP in the DVMRP Routing Table, which may be found in the
Monitoring folder under Browse DVMRP Monitoring, contains one row for each port in a DVMRP mode. Each routing
entry contains information about the source and multicast group, and incoming and outgoing interfaces. You may define
your search by entering a Source IP Address and its subnet mask into the fields at the top of the window.
Figure 10- 3 . DVMRP Routing Table window 7
237
To Next Page
Loading...
