DXS-3326GSR Gigabit Layer 3 Switch
Figure 6- 48. Setup Forwarding ports window
This window allows you to determine which port on a given switch in a switch stack will be allowed to forward packets to
other ports on that switch.
Configuring traffic segmentation on the Switch is accomplished in two parts. First, you specify a switch from a switch
stack by using the Unit pull-down menu, and then a port from that switch, using the Port pull-down menu. Then you
specify a second switch from the switch stack, and then you select which ports (or different ports on the same switch,) on
that switch that you want to be able to receive packets from the switch and port you specified in the first part.
Clicking the Apply button will enter the combination of transmitting port and allowed receiving ports into the Switch’s
Traffic Segmentation table.
The Unit drop-down menu at the top of the page allows you to select a switch from a switch stack using that switch’s Unit
ID. The Port drop-down menu allows you to select a port from that switch. This is the port that will be transmitting
packets.
The Unit drop-down menu under the Setup Forwarding ports heading allows you to select a switch from a switch stack
using that switch’s Unit ID. The Forward Port click boxes allow you to select which of the ports on the selected switch will
be able to forward packets. These are the ports that will be allowed to receive packets from the port specified above.
Click Apply to enter the settings into the Switch’s Traffic Segmentation table.
System Log Server
The Switch can send Syslog messages to up to four designated servers using the System Log Server. In the Configuration
folder, click System Log Server, to view the screen shown below.
Figure 6- 49. Current System Log Servers window
The parameters configured for adding and editing System Log Server settings are the same. To add a new Syslog Server,
click the Add button. To modify a current entry, click the hyperlinked number of the server in the Index field. Both actions
will result in the same window to configure. See the table below for a description of the parameters in the following
window.
90
To Next Page
Loading...
